I recently added the KXAT1 antenna tuner kit to my Elecraft KX1. The antenna tuner allows me to automatically tune up any non-resonant antenna quickly. Construction took one evening. As usual, winding the toroids was perhaps the most tedious part, but "zen-like" while I was doing them (as I heard it put by someone). I did have trouble with the transformer. It can be tricky and I'll warn other kit builders to check out this thread if they have trouble. I also found some pictures from a japanese ham helpful, but I've since lost them. :(
After building and installing the tuner, I purchased 40ft of some "silky" 26AWG wire from TheWireMan as suggested by Elecraft. I cut the wire to give me two lengths. One length is 24ft and the other 16ft. The 24ft length is my radiating element and the 16ft acts as my ground. The tuner quickly finds a nice 1.1-1.0 match and gives me full KX1 power out (~4W). It makes for a very lightweight, field-portable antenna. I can also use my crappie poles to elevate one end if trees are unavailable.
I use a BNC-to-binding post that I purchased at EPO in Houston. While at EPO, I also picked up a small 12V 1.3Ah gel cell battery. The UB-1213 is about 3.8" x 1.7" x 2" and provides adequate power for portable QRP work. If I was going to operate for very long, I may go with a little larger capacity gel cell, but for now this makes a very lightweight and super portable setup that allows me to get one the air quickly.